Page 1 of 1

Finished Task without Check In

Posted: Fri Nov 17, 2017 2:00 am
by jyoung
I screwed up.

Apparently I had a brain meltdown and finished a task before checking in the components.

The components ARE NOT on the iSeries Master.

The VL IDE says I can't open them because they are not checked out. I can't check them out, because they don't exist on the iSeries.

Is there anyway to force the IDE to open a component without a checkout so that I can check it in under a different task?
Capture.PNG
Capture.PNG (13.58 KiB) Viewed 1482 times

Re: Finished Task without Check In

Posted: Fri Nov 17, 2017 3:50 am
by atostaine
Can you get partition security access? You can open and check anything you want in with that.

Alternately, you could edit the task file manually and set the task back to WRK. DC@F75. Then refresh system initialization.

Re: Finished Task without Check In

Posted: Fri Nov 17, 2017 4:21 am
by jyoung
Ahh, I forgot about the PSO.

I was able to use the PSO to get everything checked in and back to normal.

Thanks Art!

Re: Finished Task without Check In

Posted: Fri Nov 17, 2017 9:20 pm
by kno_dk
Hi.

what is partition security access and where do I find it?

/Klaus

Re: Finished Task without Check In

Posted: Sat Nov 18, 2017 1:22 am
by jyoung
Basically you log in as the Partition Security Officer (PSO). This is typically XXXPGMLIB user that was created during the install.