Page 1 of 1

Compilation Linkage Failed (SOLVED)

Posted: Fri Jul 19, 2019 7:17 am
by paularstall
I have done a fresh install of 14.2 with latest epc's on a laptop (VCS system) for a new developer.

All seems to work ok apart from I can't seem to compile any objects at all in the IDE

The compilation logs show a sucessful build output however the compile output seems to show a failure.
The final message saying - Compilation and Linkage of Component xxxxx ended

Any ideas what is likely to have caused this, I've used the exact same setup which works for 3 other developers.
Compile error.jpg
Compile error.jpg (96.68 KiB) Viewed 167 times

Re: Compilation Linkage Failed

Posted: Sat Jul 20, 2019 12:05 am
by atostaine
Try turning off compile component only when necessary. IMO that setting is worthless. If I click compile I want a compile.

Re: Compilation Linkage Failed

Posted: Sat Jul 20, 2019 7:34 pm
by paularstall
Thanks for the suggestion.
However that didn't work. It's with lansa support.
Agree about it being a bit of a pointless function though if I click compile I want to compile. ;)

Re: Compilation Linkage Failed

Posted: Wed Jul 24, 2019 4:47 pm
by paularstall
This was caused by how the users admin rights had been setup here.

After adding the user to the group admin policy I re-installed LANSA and all worked ok.