This Q&A forum allows users to post and respond to "How Do I Do ....." questions. Please do not use to report (suspected) errors - you must use your regional help desk for this. The information contained in this forum has not been validated by LANSA and, as such, LANSA cannot guarantee the accuracy of the information.
jyoung
Posts: 694 Joined: Thu Jan 21, 2016 6:43 amLocation: Oklahoma City, OK USA
Post
by jyoung Fri Nov 17, 2017 2:00 am
I screwed up.
Apparently I had a brain meltdown and finished a task before checking in the components.
The components ARE NOT on the iSeries Master.
The VL IDE says I can't open them because they are not checked out. I can't check them out, because they don't exist on the iSeries.
Is there anyway to force the IDE to open a component without a checkout so that I can check it in under a different task?
Capture.PNG (13.58 KiB) Viewed 7373 times
atostaine
Posts: 696 Joined: Wed Jan 20, 2016 7:38 am
Post
by atostaine Fri Nov 17, 2017 3:50 am
Can you get partition security access? You can open and check anything you want in with that.
Art Tostaine
jyoung
Posts: 694 Joined: Thu Jan 21, 2016 6:43 amLocation: Oklahoma City, OK USA
Post
by jyoung Fri Nov 17, 2017 4:21 am
Ahh, I forgot about the PSO.
kno_dk
Posts: 221 Joined: Tue Feb 23, 2016 12:00 am
Post
by kno_dk Fri Nov 17, 2017 9:20 pm
Hi.
jyoung
Posts: 694 Joined: Thu Jan 21, 2016 6:43 amLocation: Oklahoma City, OK USA
Post
by jyoung Sat Nov 18, 2017 1:22 am
Basically you log in as the Partition Security Officer (PSO). This is typically XXXPGMLIB user that was created during the install.