Where is Audit Info Store

[caseywhite]

Does anyone know which file either on IBM i or Windows that the audit info about a function source is stored. On green screen you can see the user, date, time and task by pressing F9 when a function is open. On Windows you can see this beside each line of code by enabling the audit info. I want to query this table to verify what lines of code were changed in which functions for a certain task. I can't seem to find where this is stored. I see some cryptic data in DC@F85 but can't seem to sort out how to read it or if that is even it.

[MarkDale]

Hi Casey,

If its lansa function source,
IBMi - the line source is in DC@F29 (command) and there are multiple DC@F30 records for each line. I think the audit info is appended to the end of the value in F30PRM on the last DC@F30 for the source line.

Windows - I think LXXF29 has all the source for a line of source.

(Thats assuming it is lansa function source you want. Component source (reusable parts etc) is in DC@FRD / LXXFRD)

(I think thats right, though I don't have a lansa installation to check)

[René Houba]

Hi Casey,

Do you want to see this information on the iSeries or Windows?

[caseywhite]

Thanks Mark.

Windows was much easier to read. I found it as you said in LXX29 in the column X29PRM. Below are the positions of the values I was looking for. Seems like the audit info is at the start.
Date: 10
User: 18
Task: 28

I only needed function source for now but I checked LX_FRD and see that it stores the info at the end of the line rather than at the start.

With this info in hand I have what I need.

Thanks again.

[caseywhite]

Hi Renee. IBMi or Windows is fine. Based on the info from Mark it appears that it is easier to read it in Windows from what I can see, but if you have some tips on reading it on IBMi I would appreciate the tips.

Thanks.

[René Houba]

Hi Casey,

I was thinking about the iSeries Impact List option, but I just checked: you can't check for task details there!!